Author Topic: Crosman gas ram is "OK"  (Read 7378 times)

Offline shady816

  • Sr. Member
  • ****
  • Posts: 327
    • http://thehowellnet.com:82
Crosman gas ram is "OK"
« on: June 07, 2010, 01:57:54 PM »
A week ago or so I posted my disappointment with a replacement ram for the one that went flat and after the install in my hunter 440 it would only produce 550 fps or so but it felt when cocking it that it was all there and sounded just like the old one before it went bad. On Saturday night I turned out a top hat and spring guide and commenced to revert back to the spring when I noticed the ram front plastic cap had large cuts and scrapes on it so I started to investigate and when I put it in the piston noticed that it was very snug and the cuts were made buy the cut out in the piston so either the ram was to big or the piston to small, I do not know but I do know that after one minute in the lathe the ram fit with a little tolerance so I went ahead and reassemble the action and tested it thru the crony without installing the stock and WHALA it was pushing jsb 8.4 at 930 fps with out problem. the gun will most likely settle into 900 fps with those pellets after a good 200 shots and I think I have finally settled into the keep it under 950 fps thing. I have tried and achieved 1000 fps and slightly above but could not hit anything with any consistency past ten yards.

Offline kiwi

  • Hero Member
  • *****
  • Posts: 1410
    • http://www.nzairgunners.com
RE: Crosman gas ram is "OK"
« Reply #1 on: June 07, 2010, 05:38:51 PM »
Hi..
sounds good..
I have a 440 turning up sometime ..
Q..Where did yer get the gas ram from..?
PYD air don't sell them unless they do the instal..
And about $200nz to get a Theoben unit from the UK

Pete
Kiwi

Spring guide sets...  http://www.trademe.co.nz/Members/Listings.aspx?
http://www.nzairgunners.com

If guns are outlawed ONLY outlaws will have guns

A tin of Gamo pellets is like a box of chocs U never know what yer going to get.....



Offline LongIslandArcher

  • Sr. Member
  • ****
  • Posts: 341
    • http://
Re: Crosman gas ram is "OK"
« Reply #2 on: June 07, 2010, 08:16:01 PM »
Pete, you can get the gas rams here: http://www.airgunwarehouseinc.com/crosman-nitro-piston-springs.html
Unlike PyramydAir, they will will send you the gas ram.

Offline kiwi

  • Hero Member
  • *****
  • Posts: 1410
    • http://www.nzairgunners.com
Re: Crosman gas ram is "OK"
« Reply #3 on: June 07, 2010, 08:56:29 PM »
Thanks  LI
Kiwi

Spring guide sets...  http://www.trademe.co.nz/Members/Listings.aspx?
http://www.nzairgunners.com

If guns are outlawed ONLY outlaws will have guns

A tin of Gamo pellets is like a box of chocs U never know what yer going to get.....



Offline djmyers

  • Sr. Member
  • ****
  • Posts: 489
    • http://
RE: Crosman gas ram is "OK"
« Reply #4 on: June 08, 2010, 07:23:38 AM »
Thats awesome it was something fixable. The Gas rams are nice. I like the one I have.
Gamo Hunter gas piston GRT 3 leapers 3-9x40ao
Big Cat GRT 3 leapers tactedge  
Diasy 120
RWS 350 mag PG2 leapers 4-16x50ao
Crossman 2200
Crossman 2250
Crossman 1377
Daisy 880
2 Chinese underlevers
2 European break barrels.

Offline shady816

  • Sr. Member
  • ****
  • Posts: 327
    • http://thehowellnet.com:82
Re: Crosman gas ram is "OK"
« Reply #5 on: June 08, 2010, 11:29:01 AM »
Yes DJ i am very pleased with the 440 with a gas ram it shots with athority thats for sure and ended up having to shot 8.4 or higher grain to keep it under the sound barrier and with beeman fts it will stack'em out to thirty yards and peter " Kiwi" i will not say good or bad things about crosman rams but i will say the first one failed with less than 1500 pellets thru it and i hear the theoben rams are of better quality but don't know by owning one i only hear this.