GTA
General Discussion To Gateway To Airguns => Airgun Gate => : RedFeather November 24, 2008, 01:50:39 PM
-
How does Gamo attach the scope rail on the Shadow Supremes? Is it tacked on? Not like the removable base type.
Thanks in Advance,
RedFeather
-
On my Gamo Shadow Supreme there are two allen screws that that actually hold the riser on.
-
My Shadow Supreme is just like my Varmint Hunter circa 2004. The rail has three shallow depressions which are either for stops or they are tack welds, then a smaller hole at the rear that goes all the way down to the compression tube (for a stop pin?) I see no screws in through the top. Does your SS have visible receiver grooves?
(I thought you might be hanging around. Asked this twice now with no luck.)
-
Well it looks like I was wrong Red. I checked my new Gamo 440 which has the same riser on it and no scoope so yes it has 4 shallow holes with one stop pin hole. I would bet that those are part of the riser which is welded to the action. I never had a problem with them before. I have always ued accushot 1 piece mounts on mine and use the stop pin hole for the mount stop.
-
Thanks Gene. Your reply has answered a question that has bothered me for a while now. Love this place...always have.