GTA

PCP - HPA - C02 Gate => PCP DarkSiders Forum => : tyrrund December 13, 2008, 03:53:10 PM

: hose size
: tyrrund December 13, 2008, 03:53:10 PM

I have a regulator that i need to get a hose built for a condor being built at talontunes. Im trying to find out what fitting i need for the condor end of the hose?  Thx Ken

: RE: hose size
: melloroadman December 13, 2008, 04:04:03 PM

Ken may be these links will help .Marvin
http://www.gatewaytoairguns.com/airguns/forums/thread-view.asp?tid=12534&mid=98863#M98863

: RE: hose size
: tyrrund December 13, 2008, 04:08:06 PM

So I need the hose to be 1/4" male bspp  ?  

: RE: hose size
: kiwi December 13, 2008, 04:34:48 PM

My hose's are...
1/4 hose that has a 12,000psi burst rating.
1/8 bsp male thread on the tank end.
"for the Evanix & career" Is a 1/4 JSC Female
thread to fit the pobe
"JSC threads are a standard Hyd hose fitting"
BSP thread = British Standard Pipe.
BSPT  -  T = Tapper

Ps .. Keep the hose short
so you don't lose much air
between fills/top ups

: RE: hose size
: melloroadman December 13, 2008, 04:51:25 PM

Yes that would work if you can get some one local to do it . But that may not be easy . There are several ways to do it . Air Hog would probable be able to help you . What I did since my other rifles use a foster quick connect was I had Air Hog send me the fill adapter with a Foster male end on it . They may not always be the cheapest but this is their specialty and they know what they are doing .Marvin

: RE: hose size
: tyrrund December 13, 2008, 04:56:33 PM

So my best bet is to give them a call monday im thinking. I was also thinking of putting some sort of bleed off.  my regulator has a 1/4" female .

: Re: hose size
: kiwi December 13, 2008, 05:16:59 PM

Tyrrund..what type of regulater are you useing?
A air gun/paint ball gun fill unit or a suba reg?

: Re: hose size
: tyrrund December 13, 2008, 05:21:58 PM

Its a regulator for nitrogen 6k psi. looks like a standard reg. with 2 gauges and a screw for adjusting outlet pressure.  It has the fitting to connect to my nitrogen tank. It is just missing everything on the outgoing of regulator.

: Re: hose size
: kiwi December 13, 2008, 05:31:09 PM

OK..The out let thread size should be 1/4 BSP as thats standard
for a gas reg. But every now and then yer come across a odd ball one.

: Re: hose size
: tyrrund December 13, 2008, 05:33:13 PM

Thats correct im just trying to figure out what all i need to get so it will be ready when my rifle arrives.  :)

: Re: hose size
: melloroadman December 14, 2008, 04:32:51 AM

A.H. is into nitro as well and will probable know exactly what you have and need . But you might be the luck one that has a local gas company that knows what is going on and can help you as well . Good luck Marvin