GTA
PCP - HPA - C02 Gate => QB-7X Gate -W/Co2 & HPA => : steady41 December 16, 2008, 09:21:14 AM
-
I've a QB 79 on HPA fitted with Wevo tank and Ambush regulator upped to 1050psi output. I'd like to fit an 1800psi burst nut on on the tank block(low pressure side)for peace of mind. I reckon it could go on the side of the tank block(drilled and tapped) picking up pressure from transfer hole feeding gun from regulator
Questions are: what thread type is nut.(3/8 UNF??) Does the nut have to seat in the drliled and tapped hole, with narrower hole to pick up pressure , or would it be OK to have one dia hole, and seal using PTFE tape on on burst nut threads.
Any input appreciated .