GTA
General Discussion To Gateway To Airguns => The Shop => : Phil_B February 03, 2009, 09:22:22 AM
-
(http://i272.photobucket.com/albums/jj196/njphil/DSC01005.jpg) (http://s272.photobucket.com/albums/jj196/njphil/?action=view¤t=DSC01005.jpg)
(http://i272.photobucket.com/albums/jj196/njphil/DSC01006.jpg) (http://s272.photobucket.com/albums/jj196/njphil/?action=view¤t=DSC01006.jpg)
(http://i272.photobucket.com/albums/jj196/njphil/DSC01014.jpg) (http://s272.photobucket.com/albums/jj196/njphil/?action=view¤t=DSC01014.jpg)
-
Phil,,nice job,,now I know where to get gun racks made!!!!!!! LOL!!!
-
SURE!!!!
Just found out 2 days ago I'm unemployed for a little wile so I got the time...
-
That's a heavy duty one buddy, nice job.:) Ed
-
Yup....that sure looks like a heavy duty one....good job. I'm in the process of building one that looks like Gene's.....
-
Fantastic Phil!!! Thats a nice one and it looks strong too.
The airgun hobby is an excellent way to pass the time when you are unemployed. I know that from personal experience(http://../jscripts/tiny_mce/plugins/emotions/images/smiley-smile.gif)
-
Looks good, Phil.
I had a similar set up with a C-clamp, but later modified mine. I made an adjustable rear block out of hardwood 2 x 4, augured a 7/8 ths (I think) hole through the block, then epoxied a long "coupling" nut into the block. I replaced the shorter threaded portion of the C-clamp with a 1-ft threaded rod so I could get a much longer travel on the business end of the compressor, my C-clamp "head room" being a bit short for one of the rifles I was working on. I put two regular nuts on the rear end, locking them together, and then just use a 3/8rh inch ratchet driver to run it in and out under a load. I managed to get the hole retaining the coupling nut crooked, but I just squared up when I drilled the vertical holes to hold the block to the base. Not very elegant, but it has worked OK so far for the few rifles of my own that I have worked on.