GTA
Gateway To Product Reviews => Air Gun Mods and Tunes => : ciphery_22 February 09, 2009, 01:45:50 PM
-
I own a CZ slavia 631 lux >177cal. and have some isues. I do not own a cronograph but I do belive that the gun should be able to punch a hole in a cambels soup can with a pointed deablo,crossman,bemann pellet. nothing works. The gun is seriously lacking in balls. I an cock it with minimal effort and the seal is in mint condition. It is a fairly new gun with only 200 or so sots through it. I know it takes some tme to break in a new gun but. It is a weak spring I am comfedent of it.
IS THERE A WEB SITE WHARE I CAN GET A BETTER THAN NEW SPRING?
I can not find any sites selling springs or even other parts for a CZ slavia 631,other than CZ and their springs are.... :0
-
If you want to get rid of it, Im interested.....
-
The CZ 631 is not meant to punch holes in tin cans..:) It can be and extremely accurate paper puncher. The CZ 631 .177 shoots in the low 600 fps range. If you want a tin can destroyer then buy something like a B-26 .177 or Gamo .177. They shoot in the 900 fps range. There is nothing wrong with your CZ and it would make a great 10 meter shooter.
-
I've got a Gamo Whisper Deluxe .177 with CDT Turbotune (Maccari spring, new trigger mechanism). It has a nice BSA scope mounted, and it is well over 1,000 FPS.
This rifle will pop a can in the air.
I might consider a trade of some type, do you want to exchange photos?
-
My CZ slavia 631 in its current state.
Pic 249 shows the small dent in the beach wood stock. ( it will most likely steam out with a clothes iron and a towel.)
Pic 250 shows the minimal wear to the blueing on the side of the barrel block where it rubs against the receiver.( very new gun)
{things you can't see}
polished trigger and sear mating surfaces. polished trigger(where it rubs against the tension adjustment spring}, polished piston,electrical tape installed on bottom of receiver to prevent cocking lever from removing blueing, new stainless steel 6-32 trigger adjustment screw, epoxy bedded stock/ receiver mounting surfaces. Bore is in excellent to mint condition and has NEVER seen a steel dart .gun has been fired 200 or so times and has been very well maintained with proper storage techniques.
-
I have a 630 i modif ,polish trigger parts,change spring bigger,new seal ,get longer stroke travel piston 1/2 longger,redue the stock!
Result chrony at .177 i get 785 fps and wors very well here the pic
http://pic20.picturetrail.com/VOL1371/6153690/14960121/290640575.jpg
http://pic20.picturetrail.com/VOL1371/6153690/14960121/290789362.jpg