GTA

General Discussion To Gateway To Airguns => The Shop => : kiwi February 23, 2009, 11:48:46 AM

: Fill probe adapter ???
: kiwi February 23, 2009, 11:48:46 AM

Has anyone made/seen a adapter so that a fill probe
from one gun can be used in another type of gun.
Thinking of Career probe into a Evanix.

$135nz to get a Evanix probe from the US..

Mite go have a play on the lathe.

: This may work
: kiwi February 23, 2009, 03:26:57 PM

Its half finished....
Just bore it to take the career probe
& cut ti length.
Bad day...I stuffed up was meant to be
8.75mm but i made it 8.7  shouldn't hurt
"fingers crossed"
The hole it goes in is 8.9mm  
the career has 0.15 clearance
mine has 0.2 so its 0.05 to small
hope it don't leak