GTA

General Discussion To Gateway To Airguns => Gamo Gate => : longislandhunter January 27, 2007, 03:20:36 AM

: Filled S1k Hollow Stock
: longislandhunter January 27, 2007, 03:20:36 AM

Well, followed Genes' advice and went to a local home decorating store and found a supply of memory foam in large bags already cut into small pieces.  Took the stuff home and proceeded to fill the hollow areas of the stocks on my 4 S1K's ,,,,,, you were right Gene,,,,, had a very positive effect.  Later today gonna fill the stock on my CFX and will be doing the same on a friends S1K.

I'd like to fill the stock on my Winchester 1000 but I can't see any way to get the butt plate off.  Don't see any screws or any other hardward holding it on.  Anybody have any suggestions?  Thanks.



Jeff

: Re: Filled S1k Hollow Stock
: DanoInTx January 27, 2007, 08:22:12 AM

"I'd like to fill the stock on my Winchester 1000 but I can't see any way to get the butt plate off. Don't see any screws or any other hardward holding it on. Anybody have any suggestions?"

Bandsaw?

No idea, but there was a chance left wide open for me to be a smart lass. so I took it:)

Dan

: RE: Filled S1k Hollow Stock
: shadow January 27, 2007, 08:41:31 AM

LOL,Dano. Anyway Jeff is the butt plate glue'd on or would it act like a plug of sorts and continue into the stock butt and can be pry'ed out.? Ed

: RE: Filled S1k Hollow Stock
: longislandhunter January 27, 2007, 09:53:21 AM

I think it may be glued on, but really not sure.  I'll keep trying to figure out a way.  As for the bandsaw Dano,,,,,,,,I'm sure that would work,,,, but I think I'll pass. :)

Jeff

: Re: Filled S1k Hollow Stock
: shadow January 27, 2007, 12:03:48 PM

I like the memory foam in my airrifles, I can add or remove as needed. Ed