GTA
General Discussion To Gateway To Airguns => The Shop => : ronbeaux June 25, 2009, 11:05:41 AM
-
How do you adjust this scope to get lower when you run out of elevation adjustment??? I would normally shimm the back end but can't figure this one out.
-
No answers for you buddy just bringing your post back up to see if any of the family here can help you out.:) Ed
-
You probably need to bend the barrel up LOL
-
Ronbeaux, there's another thread where a member ran out of "UP" elevation and the gun is still shooting low.....after shimming the rear of the scope he's doing fine now. Actually I just did that yesterday while experimenting shooting out to 50 meters....ran out of "UP" clicks and still shooting low. So for you....It would be the reverse....if you're shooting high and ran out of "DOWN" clicks.....shim the front end.
Forgot to mention...that thread is in the "Scope and Mount Review" section/Gate.
-
Yeah, I know all about scope shimming. There is no way to shim this red dot.
-
That's true....it's one solid unit....I had forgotten about that. Bend barrel up or sell that thing....
-
Better yet, since it wouldn't work on my pistol either, I got a RMA# and I'm shipping it back for a refund. They were nice about it. It's almost like the internals are mis-alighned or something. The travel on the elevation is not enough to compensate.
If I knew how to take one apart I would go into it and adjust it.