GTA
General Discussion To Gateway To Airguns => Airgun Gate => : eddy4753 September 20, 2009, 03:33:41 AM
-
Hello, being relatively new to AGs at this level I have allot to learn, so please bear with me. :)
I have a new Leapers Accushot 3-9x44 AO mil-dot scope. When I adjust the power to about 8 or more I see what appears to be and is the inside of the scope tube.
Moving my head and/or eye has no positive affect towards eliminating this phenomena. :0
Am I loosing my mind or what's left of it, LOL or is my new scope defective?
None of my other scopes have this affliction.
All reply's are greatly accepted.
tia...... Eddy
-
Seems like your scope eye relief is set too close. Might help to slide the scope forward then check..mark where you normally rest your cheek and should see the eyebell & crosshair minus seeing the inside of your scope. Try here mid section >> http://www.pyramydair.com/site/articles/scopes-part2/
-
Thanks BENTONG, Yeah I read and did all of the setups from suggested link, same problem soooooooo I tried again and what I did find was that @ higher magnifications you have to search forever to get a clear picture, verrrrrrry sensitive along with some grayness with loss of sharpness.
All in all it's a great scope except at higher powers where I need it the most do to old eyes.
Thanks......Ed