GTA

General Discussion To Gateway To Airguns => Gamo Gate => : March 14, 2007, 08:05:26 AM

: Tuning Gamo Viper .177cal?
: March 14, 2007, 08:05:26 AM

With the heat of summer approaching, I'm giving serious thought on having my new Gamo Viper tuned. Who would I contact?
I'm serious!!!! 8)

: RE: Tuning Gamo Viper .177cal?
: CharlieDaTuna March 14, 2007, 08:58:03 AM

Hi David:

You might want to take a look here.

http://charliedatuna.com/

: RE: Tuning Gamo Viper .177cal?
: shadow March 14, 2007, 10:03:22 AM

Hehe, ask and you shall recieve. Ed

: Re: Tuning Gamo Viper .177cal?
: Gene_SC March 14, 2007, 10:08:49 AM

Well David, I got 13 of dim Gamo's and everyone has been tuned by CDT.. Everyone of them are Great Shooters after CDT tuned dim.. I am sure hundreds of other CDT air gun clients will say the same...:)

Gene

: Re: Tuning Gamo Viper .177cal?
: March 14, 2007, 11:53:41 AM

Thanks, guys... I'm checking out CDT's website. 8)

: Re: Tuning Gamo Viper .177cal?
: Big_Bill March 14, 2007, 02:28:22 PM

Hay Gene,

I went to charlies web site, and is shop allways that neat ?

I don't know if I would trust a fellow that sorts out his screwdrivers and pliers !

Kinda scary !

If my shop looked half that neat, I'd have myself committed. Not even one thing to fall over, just ain't right ?

lol

Bill

: Re: Tuning Gamo Viper .177cal?
: Gene_SC March 14, 2007, 02:43:35 PM

LOL Bill.......... funny you asked that...... hehe  Ya Bob runs a tight ship over there in his garage.. Even today I went to have lunch with him and he was over on the lathe, sweeping it with a wisk broom in one hand and vacum in the other... lol

If Bob misses something that falls on the floor, Fritze will take care of it, just like last week when he re-shaped a plastic piece on my S1K that I had appart over there on his bench.. I dropped it on the floor without Bob or me knowing and Fritze must of immedeatly claimed it for himself.. hehe

Ya he keeps a clean shop and bench.. Them little parts, like lock washers, clips, pins, screws, etc can easily get misplaced if he did not keep his work bench spotless.. :)

Gene

: Re: Tuning Gamo Viper .177cal?
: Big_Bill March 14, 2007, 04:03:25 PM

Ya Gene,

I allways put my small parts in a deli container, mark and seal them. And I have good set of gunsmith screwdrivers that I allways put away.

But I would never arrainge my PLIERS, PALLEASSE !

And by the way Gene, I saw those Photos of your B-26, need I say more. Sweet gun !

but a clean floor ?

Bill