GTA
General Discussion To Gateway To Airguns => Gamo Gate => : SteveB March 24, 2007, 02:32:51 PM
-
I couldn't take the twanging noise any longer so I gave my S1K a tune ala CDT's "B19 Super Tune" guide. However I do have one leftover small plastic part that I can't seem to remember where it came from. I looked on the parts schematic but can't find it. I suspect it goes somewhere behind the trigger unit.
Thanks, Steve
-
Tried to post a pic but the file was too large. I'll redo and get it smaller.
-
Show us the pic and we will tell ya that you have to completly tear it down to spring again... lol
Only kidding
Gene
-
It's not a little black roller is it?????
Jeff
-
Here's the pic.
-
Steve, Here's a pic, see it at the elbow on the cocking assembly
over at the bottom right of the pic?... I hope this helps
Roald :
-
Roald, Great!! you guys are the best!!
Thanks, Steve
-
Make sure you put it in with little hump going towards the stock.. Or it will break...:( Also put it in the front slot on the linkage. Mine Gamo's have two slots so put in the front one...:)
Good Luck
Gene
-
Thanks Gene. There's no way that I would have known which way to position it without your help.
Steve
-
Steve, put a little moly under the plastic piece where it slides, OK?
Ric G
-
Just the pic I was looking for to do mine. Thanks, Roald; and you too, Steve, for bringing it up.
Ric G
-
I think I got the pic from Rich after I bought my first CFX.... I still sent it to him for a tune
anyway :D