GTA
General Discussion To Gateway To Airguns => China Gate => : kkoenning February 01, 2010, 03:40:53 PM
-
I acquired a Beeman SS1000T (belongs to my son-in-law's brother) that was "shooting all over the place". Well, I shot it at my trap from 25 feet and the pellet barely stuck in the duct seal--maybe penetrated approximately 1/16-inch.
I expect I will find that the spring is broken or the piston seal is blown, or both. I have worked on (tuned) a couple of Remington Summits, a couple of Crosman g1's, a Gamo CFX, a Gamo Big Cat, and a couple of Ruger Airhawks. This one comes apart a little differently. After I figure out how to get it apart, where can I purchase parts for it?
Thanks for your help.
-
charlie da tuna probably has a universal that will fit.
-
Check with James Maccari his sight is posted in GTA's "MALL" section. He sell's spring and piston seal replacements for airguns. I don't know what spring and seal you need but if you shoot James a e-mail he may recommend the ones needed or it may be listed at his sight. Ed
-
Check with Compasseco, I emailed them a while back for spare to my 2 yr old RS2. I just need to get measurments on the seal and spring. The TF89 has a similar powerplant based on AR1000 series break rifle. I just did want to open up my RS2 after tuning here to get the measurements for she shoot very good. Here's a clip of the email with contact.
-------------------------------
RE: Contact from Compasseco: Product Inquiry(Urgent)
Thu, January 7, 2010 11:33:14 AM
From:
staff
...
View Contact
To: leomanjr@yahoo.com
Contact our technician Steve here at 1-800-726-1696 to see if he has your part your are looking for you gun. Mon – Fri eastern standard time 9:00am -5:30pm
Sharon
-
You can order the spring and seal from Beeman.
Less the $10 for both when I bought them last summer.