GTA
General Discussion To Gateway To Airguns => Back Room => : June 20, 2007, 01:32:39 PM
-
Does anyone know what the going rate for small engines technicians is in the USA? Lawnmowers, chainsaws etc.
-
Kind of depends on the shop, but it starts at about 40 in my area.
Mike
-
Man thats good. I'm only getting nz$17 an hour. A new CFX is $500 odd. Your pay to gun cost is bloody good I envy you guys.
-
That's what the shop gets, the man doing the work is very lucky if he see's half that.
Mike
-
We charge $60 an hour as the shop rate. Employees start at $10 for apprentice up to $25 in some shops. I'm fully qualified in the Briggs & Stratton Master Service Technician course which is the top course here and not even near the best pay that I could get. Thats what happens when you work in a small shop. Will hopefully own it soon and give myself a pay rise. HEHE
-
I was an electrician before my back went out. I was just about to go into business for myself. The guy I was working for was helping me out, because he knew that he could not pay me enough, for what I was bringing in. He started paying me by the square foot per job, instead of by the hour. My wife thought that I was crasy to do that, until she saw that I was making double, as far as she knew,hehe. But since my back went out, I've had to sell 3 of my boats, fixing to have to sell 1 of my trucks+ who knows what else. I just keep telling myself things will get better, I hope.
Mike
-
Hey Andre,
When you own the shop, you have what's left over after all the bills are paid, and all the parts are ordered ! Taxes/ rent, gas, electric, insurance, water, sewer, and after all of your employees are paid. Some weeks you eat the Bear, and Some weeks the bear eats YOU !
On a good week, it's GREAT, on a bad one ;^(
-
Things always get better.
-
Got to, can't get much worse.
Mike