GTA

General Discussion To Gateway To Airguns => Gamo Gate => : CHUCKMATLOCK October 19, 2007, 12:05:20 AM

: silly question but has anyone replaced charlies trigger with the original?
: CHUCKMATLOCK October 19, 2007, 12:05:20 AM

I may send my varmint hunter back for warranty stuff with the barrel and wondered how hard it was to reassemble. I know taking it apart was easy (most things are) but I am not sure if I can get the spring and pins bakc in correctly.

Chuck

: RE: silly question but has anyone replaced charlies trigger with the original?
: Splash October 19, 2007, 12:14:10 AM

Swapping it back will be just as easy. Here's a diagram in case you don't already have one.
Mike

: RE: silly question but has anyone replaced charlies trigger with the original?
: CharlieDaTuna October 19, 2007, 01:56:25 AM

Hey Chuck.... just follow the instrucions in reverse. Just as easy to do.

: RE: silly question but has anyone replaced charlies trigger with the original?
: October 19, 2007, 05:40:25 AM

Taking a GRTIII OUT of a gun?!?!?  It just don't seem right! Don't we have to consider the GUN's feelin's?   LOL!

I'm not sure I'd be able to see clearly enough through the tears to finish the job...

;~D

Bryan

: RE: silly question but has anyone replaced charlies trigger with the original?
: October 21, 2007, 09:58:51 AM

Trigger is very simple, just look at the diagram and you'll be fine ;) The trigger is all by itself in regards to the pins.