GTA
General Discussion To Gateway To Airguns => The Shop => : hiroller May 30, 2008, 01:04:13 AM
-
I just got a 2240 and am having lots of fun with it. I plan on using open sights for now but was having a tough time with the stock sights since my eyesight isn't so great. I have a couple of 1911's that have white 3-dot sights and have gotten used to it so I decided to try dot the 2240's stock sights.
It was really simply and quick. I removed the front sight and the rear sight blade, took a center punch and marked all the spots. I used the spring loaded type center punch and punched it a few times in each hole to create a good deep dimple. I then took a 1/16" drill bit and carefully opened up the dimple just a little on all sights. The front is plastic so be careful not to drill too deep. A little white paint applied with a sharp tipped object and voila - white 3-dot sights. It's alright if you get some paint outside the holes. Just finish coating theinside ofthe holes and let the paint set a few minutes, then you can scrape the excess off the surface with your fingernail.
(http://www.lasvista.com/2240whitedot.jpg)
-
Great idea Jay, thanks for sharing.
Mike
-
Great idea!
I've got a .45ACP with the 3 dot sighting system. When I had time, I shot IPSC and Modified PPC locally and the 3 dot was the quickest for me to line up.
Good job! Guess I'm gonna have to try this when I get a chance!
Iz
-
I just smeared some White-Out on my front and rear sights. But your job looks so much better. I guess I'll have to go try your method this weekend. It looks VERY professional!
-
Thanks! Yeah, the hardest part for me was getting the center punch to stay on target. Since these sights are small, I just eyeballed it but it may help to maybe use a vise for the front sight since it was really tough holding it and getting that spring loaded center punch to make its dimple. If I did it over again, I would use something really sharp; like the tip of a drywall screw to get the dimple started on the front sight since the plastic is a little slick. The rear was no problem - just lay it on a flat surface and punch away.