GTA
General Discussion To Gateway To Airguns => Gamo Gate => : gsdguy June 24, 2008, 01:42:10 AM
-
:emoticon: I just got a Gamo Whisper Deluxe with the air venturi gas spring, and went to install the GRT III trigger. I wasn't paying attention to the great instructions and removed the wrong pin (the one that goes thru the safety spring. I realized my mistake and replaced the pin and installed the new trigger, but it won't cock. I then took a close look and found a spring that appears loose. It is a long U shaped spring at the top of the trigger assembly that probably came loose when I took out the wrong pin. I don't have a trigger schematic so I don't know how it attaches. Can anyone help? I feel really stupid because Charliedatuna included excellent instructions with the trigger.
-
at the end of this thread there is a picture of the trigger hope this helps,good luck,and welcome to the gta you will fins allot of good people and info here
http://www.gatewaytoairguns.com/airguns/forums/thread-view.asp?tid=7716&posts=9&highlight=shadow%20trigger&highlightmode=1#M55665
-
I had a similar almost exact problem a year ago. Check the instructions and disassemble the gun again and reassemble. As I recall there is a picture of how the rod (for lack of a better word) should center on the trigger. On mine even though it looked centered it was not. This may be an issue with whispers and not other gamo rifles. AS I further recall it took two additional attempts to get it aligned so that the gun would cock. I don't know about the spring that you mention is loose or is it unattached.
-
Hey Gary... you've got mail. Check your regular e-mail.
Bob