GTA
General Discussion To Gateway To Airguns => The Shop => : January 09, 2007, 05:44:48 PM
-
Question: Hhow do you make a CUBE on a lathe????
You know a cube like a dice, and you can only use the lathe.
-
Hehe,
Start with square stock and face off a chunk as long as the piece is wide:) C'mon Rich, we need somethiung harder than this!
Just messing with ya, I'm sure there is a real answer. My only real thought is to start with round stock. You'd need a 4 jaw chuck. Cut a length of round stock, flip it in the chuck 90 degrees, face it off, flip 180 degrees, face again, flip 90...etc...till you have 6 faced sides of equal size...am I close? As you can probably tell I know little or nothing about using a metal lathe, ask me how to make a set of Crosman grips from wood, more my speed:)
Dan
-
I forgot you start with a ROUND BALLl !!
This make it harder ? but you get it.