GTA

Gateway To Product Reviews => Scope and Mount Reviews => : no_lak January 20, 2010, 08:47:52 AM

: Hammerli Titan scope mount problems
: no_lak January 20, 2010, 08:47:52 AM
I was shooting today and my recoil block fell off, I tightened everything and then after another 30/40 pellets the scope slide back 3/4"+  and the block is off again... any ideas how to eliminate this problem would be greatly appreciated
: Re: Hammerli Titan scope mount problems
: gamo2hammerli January 20, 2010, 09:48:39 AM
My Titan had...and still have alot of recoil....but luckily the scope mount have not experienced the problem that you have.  Did your air rifle come with a one-piece mount?  If it came with a two piece mount I would suggest you buy a one piece one.....something with 4 or more mount screws.

Important to clean off any lubrication/oil on and in the mount rails.....use cleaning alcohol to do this.  I applied blue Loc-Tite on the mount and scope ring screws and let it cure for over 24 hours before shooting.   I did this and both the block, mount and the scope have never moved.  Use a pencil to mark the receiver where the mount start and ends.....that way you can keep an eye on it after every shot.  Hope this helps.
: Re: Hammerli Titan scope mount problems
: no_lak January 20, 2010, 09:52:53 AM
that is exacty what I was thinking but wasn't sure it was a good idea or not... Red loc-tite  probaby wouldn't be good as it is too strong! lol
: Re: Hammerli Titan scope mount problems
: gamo2hammerli January 20, 2010, 10:20:52 AM
DO NOT USE RED LOC-TITE......I think they're permanent. If you use that...you'll probably need touse a flame (Blow torch) to loosenthe bolts/screws to remove them the next time!!!!
: Re: Hammerli Titan scope mount problems
: no_lak January 20, 2010, 08:00:17 PM
I was kidding about the red loc-tite, I use tLoc-tite products  everyday at work!  I was also thinking I could use clear nail polish, it would work the same. I just don't know if the tensile strength would be good enough to handle that kind of recoil! another question is could I not just use a "cross bolt" style end block for the scope stop, something like a SHCS (Socket Head Cap Screw)  with a nut on the end? it would give plenty of tightening strength!
: Re: Hammerli Titan scope mount problems
: bodiej January 21, 2010, 06:40:30 AM
My Titan came with the "hammerli" scope as a combo.  I think it threw the scope stop off within 5 shots, no matter how tight I had it.  Took everything off and cleaned the rail (which I should have done the first time, and the cheapo scope mounts have stayed in place ever since..