GTA
General Discussion To Gateway To Airguns => China Gate => : itsnotom June 20, 2010, 09:13:46 AM
-
ive seen a few posts about adding O rings to the cocking arm. ive looked up and down the thing and cant see where they would go so can someone send a pic of where to look to see if they are already there?
-
Are you talking about tightning up the cocking arm
-
I think people are refrring to putting two o-rings on the end of the cocking arm so it doesn't "click" into the barrel. Look on the end and if it is like the TX there are two channel rings cut into it. When the arm returns it goes past the ball detent and can hit the barrel. Just saves the possibility of wearing the finish and possibly avoi slipping.
Andy
-
gotcha. i know that there was a small rubber pad there when i first got it but it didnt last one session. andy, email me your addy and ill get the shroud mailed to you. i know your good for it
-
Tom,
Will email address. I'll throw a couple o-rings in for your arm. They are the same size as the barrel 0-rings from a QB. I've got a whole bag of them.
Funds in the mail Monday.
Thanks
Andy
-
help each other out all you can
-
mike, did you get my email about the pellets?