I have a TF79T on HPA in .177. It been pretty heavily modified.
- delrin valve stem from Mountain Air, I cut a ridge into it to hold the return spring and keep it straight.
- valve has been cleared out of all but the stem and the return spring.
- Bolt has been bobbed and probed
- Transfer port replaced with ice maker tubing for improved flow
- inside of the tubes were polished up to about 1000 grit then bolt was molyed up to slide smooth
- trigger polished, molyed and adjusted
- added 1" of hardwood to each end of the stock to make it fit an adult human, then coated with bedliner.
- added custom aluminum muzzle brake with target crown from Airgun Toys
- added regulated 3000psi HPA bottle, shimmed regulator to up pressure a bit. There is a few scratches on the regulator from where I took it apart...dumb me:(
- ground away some un-needed weight from the hammer to help reduce bounce and improve shot count
Shoots JSB's about 800fps average, hammer spring could easily be replaced for much higher velocity, I wanted good shot count with quieter report. The stock could use a fresh coat of bedliner, but not needed. The action has no serious blemishes that I could find. Shoots where you point it with JSB's, I get one hole at 15 yards, haven't really shot it much past that. Below is a 10 shot string, I think you could easily get 70 shots on a 3k psi fill, probably more. Reason for selling, some need to go before others can arrive....wife doesn't know why I need more than one:(
Asking $200 shipped in CONUS PayPal ONLY, no scope, mounts, or open sights included. Reply via email, I will answer emails in order, but will not accept "I'll Take it!" on the forums, it's too confusing that way figuring out who emailed and who posted first.
email danieljnelson (at) sbcglobal.net remove the (at) and replace with "@".
Thanks for looking,
Dan
