« Reply #15 on: September 19, 2008, 06:31:22 AM »
I have a tool that was for wire rope nicro press fittings it takes a bunch of sizes and if I use it to choke the barrel it needs to be done at the muzzel end of the gun. I press it and then I need to turn it 90 deg. and re press it again what I do is use a inch lbs. tork wrench to get the same pressure both ways about 200 inch lbs. works best for me. I don't see any way of using it on the breach end of the barrel , But if it was my gun I think I would take the action apart so I could get to the nipple that the pellet goes into. and make a tool like a long steel rod with a tapered hole in the end and put the tapered hole over the nipple and shrink it smaller by hammering the tool to close up the pellet insert hole , I would keep trying a pellet for fit and go slow till I get the fit I want. the tapered hole in the tool you make will put pressure on all sides at the same time . make a test pieice out of some steel tubing or drill a hole in a steel rod to try out the tool first. before taking your rifle all apart to see if it will work. howie
Logged
Howie1a
CURRENT HERD ,, Baikal pistol M53 in 177 ,,crossman pistol 357 -177cal. ,,Bam 30 -22 cal,, RWS 320 cal 177 custom walnut stock,,QB2078 custom stock walnut cal177,, QB2078 custom walnut stock 22 cal,,B7 custom stock cal 177 ,, B12 custom stock cal 177,,B16 from shadow 177 cal,,<< ALL THE REST OF MY RIFLES FROM \"\"MIKE M. Flying Dragon Air Rifles \"\" Super nice.
