« previous next »
Pages: [1]   Go Down

Author Topic: spring for bam  (Read 1531 times)

Offline jrboon

  • Jr. Member
  • **
  • Posts: 56
    • http://
spring for bam
« on: January 18, 2009, 11:58:29 AM »
Has anyone put a Tarantula spring in a B26 and if so what was your fps with what pellet and grain.
Logged

Offline mikeiniowa

  • Hero Member
  • *****
  • Posts: 1110
    • http://airgunartisans.com/flyingdragon
RE: spring for bam
« Reply #1 on: January 18, 2009, 01:16:19 PM »
There is a good chance it won't fit, most piston ID's are .770, the smaller size is .750, looks like the T spring is .786.....if you remove the sleeve in the piston it may fit but the cocking shoe will run along the coils of the spring....
Logged

Offline jrboon

  • Jr. Member
  • **
  • Posts: 56
    • http://
RE: spring for bam
« Reply #2 on: January 18, 2009, 02:11:48 PM »
what do you think about E3650.
Logged

Offline mikeiniowa

  • Hero Member
  • *****
  • Posts: 1110
    • http://airgunartisans.com/flyingdragon
RE: spring for bam
« Reply #3 on: January 19, 2009, 03:03:23 AM »
should fit unless you have a small piston, the rear guide is approx.490 so it will be loose on the guide but some shrink wrap will fix that or a new guide...
Logged
Pages: [1]   Go Up
« previous next »