« previous next »
Pages: [1]   Go Down

Author Topic: Parts Needed  (Read 990 times)

Offline leftcoast1

  • Hero Member
  • *****
  • Posts: 2246
    • http://
Parts Needed
« on: May 30, 2008, 10:22:24 AM »
Does any one have a couple pins that go into the hammer and spring guide that go into the bolt to cock the gun. I ordered a custom built QB PCP and it's a disaster. The pins are to short to to go into the bolt so the gun will cock. Stripped screw behind the trigger that hold the end caps in place. Thanks in advance.
Logged
Jason
A couple of Springers nothin to get excited about.

Offline mikeiniowa

  • Hero Member
  • *****
  • Posts: 1110
    • http://airgunartisans.com/flyingdragon
RE: Parts Needed
« Reply #1 on: May 30, 2008, 03:05:06 PM »
Could use steel rod to make new pins...just have to find the right diameter, the screw is a 10-32 machine screw if I remember right, I do have the stock parts if you want them....a possible solution for the short pins is to drop a .177 pellet into the hole and then put the pin in, not real high tech but it will work.......
Logged

Offline leftcoast1

  • Hero Member
  • *****
  • Posts: 2246
    • http://
RE: Parts Needed
« Reply #2 on: May 31, 2008, 12:11:07 AM »
Thanks Mike. I need to goto the hardware store today to get a new rear screw. I'll shoot you an email tomorrow cause I may need some of them parts. I have to work today so I won't get to it till tonight. Thanks. :)
Logged
Jason
A couple of Springers nothin to get excited about.
Pages: [1]   Go Up
« previous next »