Thanks Jeff,
I just tryed to get one of the pin's !Pined in & going round & round Pin one side & the other side pop's out Dang it!!
it may not look the greatest but I'm going too put some JB weld on the pin's,
there allot of things I learned from this Home Tune job?/ don't over polish the cocking foot, know where you are Drilling, Broke a 1/8th off in the side I was going to Pin extra!.
Harbor FT has Break hones for $4.99?
had to hone out the chamber for about 1 1/2 hour too get all the cut's out.
(?) I could not find silacone lube any where!!
so I used moly 60 in the back of piston in chamber ?
Is this OK ?
Also I used Ultra Blue RTV silicone too make a gasket inback of the main seal ,That made a tighter fit.
And too top it off-- I got a Bad tooth that comes up or out monday :(. Been putting it off for about 3-4 years!!
the pain is up too a 9 1/2--of 10.. So will see how it goes.