Looking for........

[leftcoast1]

another R9 lol no really I'm looking for a detent for a crosman quest. I've had one on order with crosman for about 2 months. Thanks

[melloroadman]

Have you called them the order might have got lost will they were doing their month long inventory ? Marvin

[Timmyj1959@yahoo.com]

Hey Jason, exuse me for being ignorant, could you be more spacific on the part you are after for the Quest. I may be able to send you one as I have a "basket case" that I still have not got a new spring for. Maybe I could send you one & sometime in the future when you finally get yours I may have a new mainspring by then?? Let me know,,Tim.

[leftcoast1]

I'm looking for the chisel piece that is in the end of the air compression tube that keeps the barrel locked into place when closed. I couldn't get the one out of my old one so I ordered one along with some other parts but it's still on back order. It is part number C1K77-012 http://crosman.com/site/manuals_crosman_rifles. This is a link to the parts diagram.

[vinceb]

Correction, I DO have one. The trick is finding it. I'll let you know.

BTW - as I remember, they punch out from the inside of the compression tube.

[leftcoast1]

Thanks Vince. I'll look at it again cause I couldn't figure it out.

[vinceb]

...because I sure as heck can't find the one I had laying around....

Sorry!

[leftcoast1]

I tried everything short of a cutting torch to get the old one out to no avail. Thanks for trying Vince.

[melloroadman]

Jason which part of the claw can you not get out .Marvin

[leftcoast1]

The detent between the forks in the air compression tube directly below the port.

[melloroadman]

Your probably ahead of me on this . I had mine apart a couple months back and can not remember . Is there not a pin or set screw in there some where ? Like I said you have probable been there and done that .  Good luck . Marvin

[leftcoast1]

I looked and didn't see anything. I have one completely apart right now so I'm going to look it over real good tonight.