Ping Melloroadman

[SAVAGESAM]

Marvin I have really enjoyed following your posts on different fill pressures. I haven't found any from you for the Talon and/or Condor tank from 3000. If you have done them please point me to them or post the results. If you haven't done any, would you consider it? Thank you.

[melloroadman]

Sam this man saved me the work on a high fill with the condor tank .If you look at it it puts you so far over the sweet spot that its not worth it .
http://www.gatewaytoairguns.com/airguns/forums/thread-view.asp?tid=11748&posts=7&highlight=.177%20condor%20shot%20string&highlightmode=1#M117270
This one put me so close to the condor fps with a higher fill rate I just stopped since I like low fills .But the fps just kept going up with the fill rates.
http://www.gatewaytoairguns.com/airguns/forums/thread-view.asp?tid=13360&posts=7&highlight=condor%20with%20talon%20tank&highlightmode=1#M117268
Here is the condor with talon tank 2800 psi
http://www.gatewaytoairguns.com/airguns/forums/thread-view.asp?tid=12546&posts=5&highlight=condor%20with%20talon%20tank&highlightmode=1#M99476
Sam I do my best to stay away from high fills . They just are not needed in many cases . I do have a new condor tank on the way that I might list some reading with . Marvin

[SAVAGESAM]

Marvin If you look at the last thread, you still have no "bell curve", which you may not want one.

[melloroadman]

I did not play with it any more Sam . I just don't see any reason to work that high of a fill rate when it is not needed to produce the same FPS. and shot count that a lower fill will do . When I shoot targets at 50 plus yards I find it easier some times not to have a curve . I can start at a 6 o'clock hold and slowly work to a 12 o'clock hold  in stead of going up and down . Marvin