« previous next »
Pages: [1]   Go Down

Author Topic: Fill probe adapter ???  (Read 1175 times)

Offline kiwi

  • Hero Member
  • *****
  • Posts: 1410
    • http://www.nzairgunners.com
Fill probe adapter ???
« on: February 23, 2009, 11:48:46 AM »
Has anyone made/seen a adapter so that a fill probe
from one gun can be used in another type of gun.
Thinking of Career probe into a Evanix.

$135nz to get a Evanix probe from the US..

Mite go have a play on the lathe.
Logged
Kiwi

Spring guide sets...  http://www.trademe.co.nz/Members/Listings.aspx?
http://www.nzairgunners.com

If guns are outlawed ONLY outlaws will have guns

A tin of Gamo pellets is like a box of chocs U never know what yer going to get.....


Offline kiwi

  • Hero Member
  • *****
  • Posts: 1410
    • http://www.nzairgunners.com
This may work
« Reply #1 on: February 23, 2009, 03:26:57 PM »
Its half finished....
Just bore it to take the career probe
& cut ti length.
Bad day...I stuffed up was meant to be
8.75mm but i made it 8.7  shouldn't hurt
"fingers crossed"
The hole it goes in is 8.9mm  
the career has 0.15 clearance
mine has 0.2 so its 0.05 to small
hope it don't leak
Logged
Kiwi

Spring guide sets...  http://www.trademe.co.nz/Members/Listings.aspx?
http://www.nzairgunners.com

If guns are outlawed ONLY outlaws will have guns

A tin of Gamo pellets is like a box of chocs U never know what yer going to get.....


Pages: [1]   Go Up
« previous next »