« previous next »
Pages: [1]   Go Down

Author Topic: Creaky Cocking  (Read 1618 times)

Offline Traolach

  • Full Member
  • ***
  • Posts: 221
    • http://
Creaky Cocking
« on: September 13, 2009, 04:52:09 AM »
I recently bought a Crosman G1 Extreme and while it shoots well especially now that I have a CDT trigger, there is one problem that is driving me nuts. When I cock it, it sounds like an old rusty back door hinge and spring. Really creaky! Other than taking the action apart, is there any thing I can do to the spring through the cocking slot that will help with the noise? Thanks!  Terry
Logged

Offline SDale

  • Hero Member
  • *****
  • Posts: 1868
    • http://
RE: Creaky Cocking
« Reply #1 on: September 13, 2009, 04:58:08 AM »
I wouldn't put ANYTHING in the cocking slot.

Either keep shooting until she breaks in and quiets down or tear it apart and perform a lube tune.

I'd opt for the tune. It's not that hard on a Crosman to do and would probably take you about an hour. But that hour will yield WONDERFUL results!
Logged

Offline tjk

  • Hero Member
  • *****
  • Posts: 2275
    • http://
Re: Creaky Cocking
« Reply #2 on: September 13, 2009, 05:56:13 AM »
Be sure to check the cocking linkage points. Just a small drop of 3in1/Marvel Oil will help. And I mean a 'small' drop. Wipe off any extra. tjk
Logged
397 Benji-98\' model    
Marksman  0035, My Fav!,CDT T\'d
Crosman Sierra-Pro,.177
Benji 392 08\'
CDT TT\'d RWS 34 .22,CP 4-16X40 AO
MM T\'d Marksman 0035
Crosman G1 Extreme
Daisy PowerLine 1000
TF-97 .22
B-28A MM T\'d
B-28 OEM Tuned by me
Beeman .22 RX-2 w/Theoben GR
Beeman .177 R1 Santa Rosa

Offline BumbleShot

  • Sr. Member
  • ****
  • Posts: 305
    • http://www.huffingtonpost.com/
Crosman Quest and their kin are easy to lube tune...
« Reply #3 on: September 14, 2009, 08:49:49 AM »
Just plan on replacing the seal when you take it apart.  You don't need a spring compressor, either.  It has about 30 pounds of preload and only extends about 1".

Logged
R9 .20; R7 .177; B40 .177; B26 .177; Tempest .177; HB .20; IZH 46m; BlueStreak

Offline Rontier

  • Sr. Member
  • ****
  • Posts: 385
    • http://
Re: Creaky Cocking
« Reply #4 on: September 15, 2009, 04:22:12 PM »
Hey,
my crosman1000 sounds like a frog!
took the stock apart, found one thing- the Roller on the cocking lever has a flat spot worn down, at about 500 pellets,
I cut a peace of 12ga allm 1" x 5 3/4 long & Drilmaled out a slot for it now the roller rides smooth on tha metal,With moly 60, then the wood stock.
Is there a site that shows how to take apart a 1000? tune up your self, without getting to deep!
Ron
Logged
Pages: [1]   Go Up
« previous next »