GAMO S1K Tune Leftover Part

[SteveB]

I couldn't take the twanging noise any longer so I gave my S1K a tune ala CDT's "B19 Super Tune" guide. However I do have one leftover small plastic  part that I can't seem to remember where it came from. I looked on the parts schematic but can't find it. I suspect it goes somewhere behind the trigger unit.

Thanks, Steve

[SteveB]

Tried to post a pic but the file was too large. I'll redo and get it smaller.

[Gene_SC]

Show us the pic and we will tell ya that you have to completly tear it down to spring again... lol

Only kidding

Gene

[longislandhunter]

It's not a little black roller is it??

Jeff

[SteveB]

Here's the pic.

[Silo]

Steve, Here's a pic, see it at the elbow on the cocking assembly
over at the bottom right of the pic?... I hope this helps
Roald  :

[SteveB]

Roald, Great!! you guys are the best!!

Thanks, Steve

[Gene_SC]

Make sure you put it in with little hump going towards the stock.. Or it will break...  Also put it in the front slot on the linkage. Mine Gamo's have two slots so put in the front one...

Good Luck
Gene

[SteveB]

Thanks Gene. There's no way that I would have known which way to position it without your help.  

Steve

[Rixtrix]

Steve, put a little moly under the plastic piece where it slides, OK?

Ric G

[Rixtrix]

Just the pic I was looking for to do mine. Thanks, Roald; and you too, Steve, for bringing it up.

Ric G

[Silo]

I think I got the pic from Rich after I bought my first CFX.... I still sent it to him for a tune
anyway